MOUNTING INSTRUCTIONS
These couplers have a push-lock mechanism that enables them to be installed on pipes without pre-dismantling.
DO NOT take the coupler apart unless absolutely necessary.
Proper installation requires the leading edge to be beveled.
The end of the pipe should be clean and round.
Keep the inside of the coupler free from sand and mud.
Mark Pipe for insertion depth.
Look inside the coupler and measure to the should near the center of the coupler. This is the insertion depth.
This measurement varies on the size of the coupler.
Push the coupler on the pipe to the mark you created.
After installing, pull the pipe forcibly by hand to ensure correct installation.
